The construction process covers the whole floor wi

2022-07-22
  • Detail

1、 Construction preparation for carpet laying on the ground

1. Carpet: flame retardant carpet

2. Carpet adhesive, carpet seam tape, linen strip

3. Carpet wood strips (barbed board), aluminum strips (barbed board), antimony strips, copper edging strips

4. Construction tools: tensioner, edge cutting machine, cutting knife, cutting scissors, paint brush, iron, snapping powder bag, flat shovel, zhongzi, etc

II. Construction process of carpet laying on the ground

process flow: cleaning the base course, cutting the carpet, nailing the strip, pressing the strip, joint treatment, paving process, trimming, cleaning

1. Clean the base course

(1) the base course of carpet laying requires a certain strength

(2) the surface of the base course must be flat, free of pits, pits and cracks, and kept clean. If there is oil stain, it must be wiped clean with acetone or turpentine, and the uneven parts should be filled and leveled with cement mortar in advance

2. Cutting carpets

(1) according to the size and shape of the room, use the edge cutting machine to cut carpets from long rolls

(2) the length of each section of carpet should be about 20mm longer than the length of the room. The width should be calculated based on the size after cutting the edge of the carpet, and snap the line to cut the edge part. Pay attention to whether the laying direction of carpet texture is consistent with the design

3. Nail wood strips and door battens

(1) when using wood strips (barbed boards) to fix carpets, the strips should be fixed on the base course 1 ~ 2cm away from the foot of the wall around the room

(2) at the door, aluminum alloy strips and antimony strips are commonly used to fix the carpet in order not to kick up and damage the edges, so as to achieve a beautiful effect. There are barbs inside the card strip and antimony strip to fasten the carpet. The long side of the antimony strip is fixed with the ground. After the carpet is paved, the short side is knocked down to tightly press the carpet surface

(3) the clamping strip and pressing strip can be fixed on the base course with nail strips, screws and shooting nails

4. Seam treatment

(1) carpet is the back seam. The seam is to turn the carpet upside down so that the two seams are flat. After sewing with thread, brush white glue and stick kraft tape. The seam should be strong and the stitches need not be too dense

read more: 1 ・ 2 ・ next page >& gt;

济南男科医院

广州肿瘤医院

曲靖皮肤病医院

Copyright © 2011 JIN SHI